The Wedge: Closing the Triangle Nobody Thinks About

The Wedge: Closing the Triangle Nobody Thinks About

Almost every veranda with a sloping roof has a gap in its sides that people do not notice until the first windy evening. It sits at the top of each side, between the highest point of the side wall and the underside of the sloping roof, and it is triangular. It is called the wedge, and closing it properly is one of those small details that separates a covered space that feels sheltered from one that only looks it.

Where the Triangle Comes From

A lean-to veranda roof slopes from the house down to the gutter at the front, so that rain runs away from the building. That fall is usually somewhere between eight and fifteen degrees, depending on the system and the depth of the roof. It is not dramatic, but over a projection of three or four metres it adds up to a difference in height of several hundred millimetres between the back and the front.

Side walls, on the other hand, are generally built square. A sliding glass wall or a fixed side panel has a flat top, set to the height of the lower front edge. The result is a triangle of open air between the top of the side wall and the roof, widest at the house end and tapering to nothing at the front.

The Wedge: Closing the Triangle Nobody Thinks About

Why It Matters More Than Its Size Suggests

Because the triangle is high up and fairly narrow, it is easy to assume it does not matter much. In still weather it does not. In wind, it matters a great deal.

Air finds the easiest way through, and an open triangle at the top of an otherwise closed side is exactly that. On a breezy day, wind spills in over the top of the side wall, runs along the underside of the roof and drops into the space. It is often worse at the house end, where the triangle is biggest and where most people put their seating. Rain driven by the wind follows the same route, which is why people sometimes find the floor wet beside a closed side wall and cannot work out how it got there.

There is a warmth issue too. Warm air rises, and a heater under a roof is fighting a constant leak of warm air out of the top of the space if the wedges are open.

What a Wedge Is Made Of

A wedge is a triangular panel cut to fit the exact angle of your roof, held in a frame that matches the rest of the structure. The common options are:

Clear glass, which keeps the light and the view and makes the side look like one continuous piece of glazing. This is the usual choice when the side below is glass.

Opal or tinted glass, which softens the light and adds a little privacy at the top of the side, useful where the house next door overlooks the space.

Polycarbonate, which is lighter and less expensive, and a good match where the roof itself is polycarbonate.

Aluminium cladding, which closes the triangle completely and gives a solid, more architectural look. This is a good choice when the side below is a solid wall or louvres.

Whatever you choose, it is generally worth matching the wedge to the wall below it, so the side reads as one finished element rather than a wall with something added on top.

The Wedge: Closing the Triangle Nobody Thinks About

Wedge Only, or the Whole Side

You can fit a wedge on its own, without anything below it. It sounds odd, but it works surprisingly well. A wedge alone takes out the high-level draught along the roof while leaving the side open at eye level. Plenty of people start this way and add glass underneath later, once they have lived with the space for a season.

What does not work as well is the other way round: a closed side wall with an open triangle above it. That gives you most of the cost of enclosing the side and not much of the benefit.

Measuring and Planning

Because every roof pitch is slightly different, wedges are made to measure. The key dimensions are the projection of the roof, the height at the house end and the height at the front, all taken on site once the structure is up. That is the reason it is worth deciding early whether you will want wedges, even if you are not fitting them straight away. The fixing points can be planned in from the start, which makes adding them later straightforward.

If you already have a veranda and the sides feel draughtier than they should, look up. In most cases, the wedge is the missing piece.

A Small Panel With a Big Effect

The wedge is not the most exciting part of a covered space, and nobody chooses a veranda because of it. But it is the detail that makes the difference between sitting under a roof and sitting in a properly sheltered space. On a breezy autumn evening, with the heater on and the sides closed top to bottom, it is the reason you stay out for another hour.

The Wedge: Closing the Triangle Nobody Thinks About

Quick Answers

Do flat-roof verandas need wedges? No. On a cube or flat-roofed veranda the sides are square, so side walls fit straight under the beam.

Can I fit a wedge myself? Wedges are made to measure and need careful fitting to seal properly. We recommend professional installation.

Does a wedge make the space darker? Not if it is glass or clear polycarbonate. Opal and aluminium reduce light at the top of the side.

What does a wedge cost? It depends on the size and material. In our current range, wedges start from around £195.

Ready to talk about your project?

Book a free virtual appointment with our team and we'll talk through your project in detail — no pressure, just straight advice.

Book a Virtual Appointment 💬 WhatsApp Us

Written by Aaron

Written by Aaron

Happiest outdoors, on a good adventure or simply in the garden BBQing with friends, family and Mable the dog.

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.